Embedded Files
There are 2 ways to setup interconnection between Hana Transceiver and Computer
Pic 1
Pic 2
I. Physical USB cable
Plug in Mini USB Cable to USB port at front Panel
Install FTDI usb driver through this link https://drive.google.com/file/d/1X8Yk5R5AMGyK3zjrec8qDIeo0o9XJ-q0/view?usp=drive_link
once Installed successfully, Verify serial Com port available under Device Manager see Pic1 left side
Audio Cable Connection
Plug in Audio in and out at rear Panel to Soundcard Line in and Speaker ports.
Recommended install Ground loop Isolator in between see the pic2.
JTDX, WSJTX and FLDIGI radio setting
Open JTDX application or FLDIGI etc... setting the radio connection set as TS480 then serial com address, select baudrate 115200 bps... tick CAT and also USB..
Press Test button (JTDX), connection successfully is green color...
Don't forget tick or enable Hamlib FLDIGI... final step press initialling button...
II. SETUP Serial Bluetooth connection to operate Digimode Application:
Switch on bluetooth connection by long press dial knob to enable main menu... Select menu no.4 Bluetooth then press F1 to activate..
Find HANA transceiver in PC then make it connection to HANA RADIO.. once connected... Right click on HANA Transceiver Icon then select properties then select services... noted serial com address..
Open JTDX application or FLDIGI etc... setting the radio connection set as TS480 then serial com address, select baudrate 115200 bps... tick CAT and also USB..
Press Test button (JTDX), connection successfully is green color...
FLDIGI go to HAMLIB menu select TS480 the radio then serial address, select baudrate 115200 bps... don forget tick or enable Hamlib... final step press initialing button...
Watch the guidance on Video
VID_20250724_112554.mp4Page updated
Google Sites
Report abuse